emenaman

I had issues with mine, nothing was sticking to it causing 100% failures. I forgot where I read it but I ended up scrubbing it good with one of those slightly abrasive green pads in warm dawn dish soap, drying it with a clean microfiber cloth and putting it on the bed with the heat set to 60c for a few minutes. It now works extremely well with pla or petg, I just wipe it down with a bit of 90% alcohol between prints. Never had any issues with the smooth and satin sheets.

Compare it to this… Watching a highly rated chef come up with the most amazing sounding and looking dinner meal over the course of a few hours. You are anxiously awaiting to take a bite and salivating for that moment. When you finally get served your plate and get to that scrumptious first bite, the biggest wave of disappointment hits and you lose your appetite.

I don’t know how else to explain it